You’ll get an error for “fan min / max”.Copy the both gcode sections into Cura 2.4. For the gcode, just go to the 2.1 version of cura in expert mode and go to the “Start/End Gcode” section.Copy the settings you see in the 2.1 version of Cura to the Machine Settings page (See screenshot).My steps are pretty similar to the initial post in this thread, but here’s an overview. I’m actually printing right now with the latest version of Cura (2.4). It was a mess… please don’t ask about it.Įdit2: version 2.3.1 is now released, updated All I did to get the fan min / max error to go away was change the number in “Regular/Maximum Fan Speed Threshold” to 30. The mythical being is fine, but the SteamEngine had to be completely re-built. Well, a PinkUnicorn had a nasty collision with a train. There may be bugs lurking, so please do not start a multi-day print then leave your printer unattended! But everything should work the same on other platforms.ĭo not trust the GCODE that it produces. This has only been tested on Linux (Debian Jessie). Z-offsets may require tweaking to achieve optimal first layer adhesion For now you will have to open the printer settings and modify this hard-coded number in the start GCODE section Until this is extracted as a setting of the User Interface, it is difficult to swap between materials. LulzBot profiles include a wipe temperature in the start gcode section, this number is material specific. Regressions – these features were not deliberately removed, they just have not been re-implemented on the new code base yet. However not all features are faster then the previous generation of Cura. Performance – Compared to 2.1, significant improvements have been made. Cura 2.3 automatically attempts to connects with printers when it is started up, so ongoing USB print jobs may be killed.On Linux, Cura 2.3 cannot be installed side by side with existing Cura Original.Many of the below problems will be fixed over time, but they have not been taken care of yet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |